IW STi Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
48 Posts
Discussion Starter #1
I just got a set of Whiteline diff bushing kit (KSB751) for my STI. The mod seems easy enough for anyone to do. However, instruction no.7 says to tighten all bolts to manufacturers specifications. Anybody who has done this mod know of the factory torque values for the three bolts involved in this mod? Actualy, there are three bolts but to are identical so there should only be two torque values. Can anyone out here please help me with this :wink:
 

·
Registered
Joined
·
240 Posts
the torque specs were in one of those "what ia that clunking noise threads", i am sorry i dont have time to find it for you, but i remember the big bolts were 80 ft.lbs.
 

·
Premium Member
Joined
·
922 Posts
I always tighten until I almost reach stupid tight. Stupid tight tends to break stuff.
 

·
Registered
Joined
·
5,261 Posts
There are 3 bolts per side, the 2 tq settings are: 73.8 ft/lbs for the big bolt (T6)(that goes through the bushing) and 24.3 ft/lbs for the outer bolts (T2). This is according to the big service manual. Hope this helps

Robert~
 
1 - 7 of 7 Posts
Top