IW STi Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,069 Posts
Edmunds Review

DTSTYLE said:
make the RMS for the speakers and amp as close as possible, you can go above the RMS for the speakers with the AMP, just be careful not to blow the speakers.
Hmm, I need to think about this. I'd think that you'd rather have an amp capable of more power then the speakers can handle. This way if you're looking for louder music your amp will not have to work near peak. Distortion from clipped amplitudes will lead to high DC voltages which will blow the speaker. I'd go with amps that supply more power than your speakers RMS values state. Just to be on the safe side.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top