IW STi Forum banner

21 - 27 of 27 Posts

·
Registered
Joined
·
618 Posts
In the NASIOC thread, somebody did it. Props to him for figuring it out, but it was pretty involved and I don't know enough about the airbag system to tackle it. 3 ohm resistor for me.
 

·
Registered
Joined
·
779 Posts
I just finished cutting the tabs on my evo x recaros. Pain in the ass! Took me 6 hours. Driver seat sliders bolted up to sparco base and ready for install in the car. This project is easily a 3-4 days project but its been fun so far.
 

·
Registered
Joined
·
50 Posts
Bump from the dead but mt 2011 STI seat heaters are not just off/high/low. Its the multi level switch.

Has anybody figured out how wire in the evo x seat heater?

My stock seat heater has 3 wires black, blue, white and yellow.
the recaro has 3. Black blue and yellow.
 

·
Registered
Joined
·
294 Posts
Does anyone know if the sparco bases are the same for EVO IX and X seats? I found that EVO IX uses these
Seat bases
Driver side base- 600SB019L
Passenger side base- 600SB019R
 

·
Registered
Joined
·
27 Posts
Bump from the dead but mt 2011 STI seat heaters are not just off/high/low. Its the multi level switch.

Has anybody figured out how wire in the evo x seat heater?

My stock seat heater has 3 wires black, blue, white and yellow.
the recaro has 3. Black blue and yellow.
no one ever figured this out?
 
21 - 27 of 27 Posts
Top