IW STi Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
385 Posts
Discussion Starter #1
Surprised of number of STi's on dealers lot...

Do any of you know where I can source the part that places a gauge in the drivers side vent. I think this is the best solution for those that only want to install a single gauge. Anyone?
 

·
So Gangster It Hurts
Joined
·
3,521 Posts
Hmmm. . . I think it's usually custom work.

From what I hear, it's just a matter of taking off the trim ring (just pops off) and removing the vent louver assembly. Realistically, it's a good idea to "tape off" the duct near the HVAC area in the center of the dash to keep hot or frigid air from blasting the back of the gauge, once installed. After that, it's just a matter of fitting the trim ring back on around the gague. . . . . . I THINK. :p
 

·
Registered
Joined
·
385 Posts
Discussion Starter #7
Ya, I have that link saved for the install of the part. Strange nobody knows where to locate the actual part.
 
1 - 8 of 8 Posts
Top