IW STi Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
So I have a 2013 sti and I installed all new brake pads and rear brake rotors. Only when I’m pressing on the brake at lower speeds not full pressure to the brake pedal is when I get a super loud squeak. I installed it great. I greased the hell out of the shim side. The pins and pretty much any metal to metal contact. Why is it still so loud?!
 

·
Registered
Joined
·
2,100 Posts
Did you lube up the sides of the pads where they sit in the calipers? I would pull them out and do that and also lube up inside of the calipers where the pads sits.
 

·
Registered
Joined
·
11 Posts
Discussion Starter · #5 ·
I cheaper out on them until I got a new wheel setup and got car quest ceramic pads. I just pulled them out and put crc brake grease on the shim. It’s a built in shim and it still squeaks a little.
 
1 - 5 of 5 Posts
Top