IW STi Forum banner

21 - 28 of 28 Posts

·
Registered
Joined
·
2,888 Posts
Discussion Starter #21
Hello...

New updates are always fun.

Here’s the deal:

- 14mm IAG studs
- GSC dual spring valve springs
- BC stainless steel intake and exhaust valves
- ported and polished heads
- plastic intake manifold for the reduced heat soak
- IAG fuel rails with aeromotive FPR
- FIC 1000cc injectors (I will need ID1700, fuck lol)
- HTA76

To tie all of this together. A revworks block will be arriving soon. I got their RW950 package - it *should* be 2-3 weeks out.

Going to sing 35psi until I get the 1700’s and then we push for 40+ on kill mode.

The RW950 package I added the O-Ring and 14mm head stud options.

This will be fun.
 

·
Registered
Joined
·
123 Posts
Hello...

New updates are always fun.

Here’s the deal:

- 14mm IAG studs
- GSC dual spring valve springs
- BC stainless steel intake and exhaust valves
- ported and polished heads
- plastic intake manifold for the reduced heat soak
- IAG fuel rails with aeromotive FPR
- FIC 1000cc injectors (I will need ID1700, fuck lol)
- HTA76

To tie all of this together. A revworks block will be arriving soon. I got their RW950 package - it *should* be 2-3 weeks out.

Going to sing 35psi until I get the 1700’s and then we push for 40+ on kill mode.

The RW950 package I added the O-Ring and 14mm head stud options.

This will be fun.
Give Performance Fuel Injection a call they're out here in Alberta and sells injectors he gets from Bosch for a much better deal. His Bosch Motorsport 1500's are a crazy good deal at around 900 Canadian.
 

·
Registered
Joined
·
2,888 Posts
Discussion Starter #23
Give Performance Fuel Injection a call they're out here in Alberta and sells injectors he gets from Bosch for a much better deal. His Bosch Motorsport 1500's are a crazy good deal at around 900 Canadian.


Beautiful, thank you for the heads up!

Side note: engine got pushed back a few weeks. Machine shop left us hanging on almost 15 blocks... so now Revworks will be doing everything in house instead of using another machinist!
 

·
'do right & fear no one"
Joined
·
8,564 Posts
i just tried pm'ing you, but your box is full. pm me again and leave your cell.

bruce
 
21 - 28 of 28 Posts
Top