IW STi Forum banner

1 - 5 of 5 Posts

·
Premium Member
Joined
·
5,963 Posts
Interested. Must consider.

Help me understand the cutting.
 

·
Registered
Joined
·
165 Posts
Discussion Starter · #5 ·
Interested. Must consider.

Help me understand the cutting.
I used to have an HKS Carbon-Ti that was angled to a degree where installing the APR diffuser was impossible without modification. I carefully cut the main section of the diffuser just enough to allow for clearance. I used a Dremel Saw-Max, so the lines are clean. There's just a tiny bit of melted clearcoat along the top edge of the fin that was cut. It's all on the inside face, though, so it's not visible when installed. Here are some pics.



 
1 - 5 of 5 Posts
Top