Just in time for my weekend project. Thanks guys!

 

Thank you! I will now purchase these overlays and install them.

 

Ok, I see the 'stache, but where are the half-naked women???

 

They are optional, we unfortunately were not able to procure any for this video

 

It seemed to me when I installed your film... that keeping everything warm with a hair-dryer really helped my install, and made the film a lot easier to conform and place...

 

Thanks for the vid. If you want to do cutouts would you do it before or after its on the car?

 

I would say after because if the film stretches and sticks more one way or the other your cutout might be off. Put it on whole, perform the cut out gently so you don't scratch the lens, and pull the piece out.

At least this would be my thinking on the matter.

 

Music was epic.

 

The women comment reeled me in.

 

Definitely cut the film after it has been installed, you need to stretch it a little to have it fit properly and that would make the cutout lose its shape if pre-cut.

 

What do you do about small bubbles after? Do some of them go away on their own? Does the bubble fairy come and smooth them out?

 

If the bubbles are fairly small, they will tend to go away with time as the film goes through various heat cycles and settles and as the water/alcohol mix evaporates. Larger bubbles should be elminated as soon as possible by either working the bubble to the edge or by peircing it with a very fine needle although the former is a much preferred method than the latter.

 

Yakkity-Sax FTW!

 

Any hints for the 2004 taillight tint install??

 

nice how to

 

What's the removal procedure of these overlays, and what kind of condition does it leave the taillights in?