[xaoc]

Up until recently when I decided to start parting out my car, I had a GT Spec (Gen II) header and uppipe, and an APS 3" Cat-less TBE. I sold the cat-back and have since decided to keep the car.

I just bought a Borla (single tip, so XR-1 I believe) from a local guy. I was wondering if anybody either has the same setup and has or could make me a video, from outside, ranging loads and rpms, or if you know of any videos?

I can find tons of Borla videos, but only one is going through my header setup, and was a low quality, two step, nasty sounding video.

Can anybody help me out here? My car is in the shop right now and I won't get to hear this for most likely at least a month. I want to know what to expect.

Thanks for the help.

P.S - I searched the forum and youtube with no luck.