[rs25]

Hey guys/gals,
Ok, if any of you out there might be able to help me out. I'm doing a Prodrive BCS swap on my car, and unfortunately, the 07 WRX doesn't have the right bracket I need, they switched in the 07's to a single post bcs solenoid. So, I borrowed my roomates car to take a few pictures of the exact bracket I'm now looking for.

I'm essentially looking for the OEM BCS shock tower bracket, and the rubber bushings and hardware that physically mount the solenoid to that bracket.

Here's a shot of what the bracket looks like installed in the car. I relocated the wiring harness to make the bracket easier to see.



and a shot of how the BCS mounts to the bracket



and a few shots from various angles to see what the bracket looks like

BACK Side

TOP

Angled FRONT

Angled BOTTOM


and this is the hardware that mounts the BCS to the bracket. To remove it from the BCS, you have to push the metal sleeve out of the rubber grommit with your thumb.



and last but not least, a shot of what the BCS looks like after the hardware is removed




I'm not sure if any of you might have the bracket laying around, but I'm hoping someone might from a tear down or a switch to a different aftermarket bcs.

Thanks for your time, Sean-

[MKTURBO]

i put a prodrive bcs on my stock 07 bracket with some modifying....i simply drilled out the pinch weld on the 07 bracket, and drilled holes in the stocker and welded studs to the bracket, and ground it smooth....it looks soo clean its redicuolus!!! pm me if you want to send me your bracket and ill modify it and weld it for you....