IW STi Forum banner

Perrin Transmission Mount Install on Ramp?

996 views 4 replies 5 participants last post by  ChefPhil 
#1 ·
Hey Everyone,


Has Anyone installed the Perrin transmission mount on a pair of ramps instead of a lift? I just ordered my transmission mount and im wondering if the angle induced by the from wheel being higher than the rear will flex the frame enough to make the cross member holes not line up?
 
#4 · (Edited)
Did clutch on jack stands. Cross member on ramps should be fine.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top